Fitting / Replacing the Bezel
Alternative colour bezels are available.
To install the bezel align the 2 lugs on either side of teh bezel with the holes in the downlight.
Push the bezel lugs through the holes in the downlight and twist 30 Degrees clockwise to lock in place.
To remove the bezel twist 30 degrees anti-clockwise and pull down.
Cut a suitable hole 70mm in the ceiling ensuring that it does not infringe with electrical cables, water/gas pipes or ceiling joists.
Carefully fold back any insulation material so not to cover the luminaire and allow free circulation of air.
Remove the terminal cover on the driver.
Connect the mains cable into the terminal block, ensuring correct polarity is observed and that if stranded cable is used that all strands are terminated.
Re-fit the terminal cover securing the mains cable under the cable clamp.
Plug the fitting into the loop in - loop out driver. This can be done at a later date following decoration if reqruired.
Fit the downlight into the hold in the ceiling with the 2 spring clips supplied.
Test for correct operation.