QUARTZ IP65 Fixed Fire Rated Dimmable COB LED Downlight - 3 Colour Temperatures

£30.83 ex VAT
Product Code: LQD05000
Click here to login & buy on your trade account

Features at a Glance

  • Switchable Colour Temperature
  • 10 Watt
  • IP65
  • 60 Degree Beam Angle
  • Dimmable
  • Supplied with 3 Bezels, White, Brushed Nickel and Polished Chrome
  • 4 Year Warranty
  • 70mm Deep

Colour Temperature

This fitting can be set to either;

Warm White - 3000K (600lm)
Neutral White - 4000K (700lm)
Cool White - 6000K (650lm)

Before installing the downlight line the switch up on the back of the downlight with the preferred colour temperature.

Dimming

The fitting comes as standard with a  dimmable loop in - loop out LED driver that allows the user to regulate the light output to best suit their lighting needs.

Please note;

  • The driver can be used with most trailing and leading edge dimmers.
  • Please examing carefully the manufacturer's guide on the dimmer switch you intend to use and check copatibility.
  • In some cases you may need to change or upgrade your dimmer switch if the unit flickers or does not dim smoothly.

Fitting / Replacing the Bezel

Alternative colour bezels are available.

  • To install the bezel align the 2 lugs on either side of teh bezel with the holes in the downlight.
  • Push the bezel lugs through the holes in the downlight and twist 30 Degrees clockwise to lock in place.
  • To remove the bezel twist 30 degrees anti-clockwise and pull down.

Installation

  • Cut a suitable hole 70mm in the ceiling ensuring that it does not infringe with electrical cables, water/gas pipes or ceiling joists.
  • Carefully fold back any insulation material so not to cover the luminaire and allow free circulation of air.
  • Remove the terminal cover on the driver.
  • Connect the mains cable into the terminal block, ensuring correct polarity is observed and that if stranded cable is used that all strands are terminated.
  • Re-fit the terminal cover securing the mains cable under the cable clamp.
  • Plug the fitting into the loop in - loop out driver.  This can be done at a later date following decoration if reqruired.
  • Fit the downlight into the hold in the ceiling with the 2 spring clips supplied.
  • Test for correct operation.

Concealed Door Straighteners

Fully conceal the straightener bar by morticing it into the door, cover it with a cap then veneer over it to give a seemless finish.